04-12-2011, 06:02 PM
Rick here are the castings I did.
The Vanguard parts are bugger to do as their so small the little antenna things snap off when pulling out the mould
My fault as I did a short cut on the moulds. Ive learnt that lesson before & learnt it again. There are no short cuts when moulding parts
Anyway with these parts all you need is the La Seine parts for the bridge face(Rectagle parts at top of face & cranes at bottom) & its accurate. Again I have that kit in transit so if you want the parts you'll have to wait until I get it to do them
Also in the La Sein kit are the square parts those White Road Boss hydrolics sit on top of 
The Vanguard parts are bugger to do as their so small the little antenna things snap off when pulling out the mould
My fault as I did a short cut on the moulds. Ive learnt that lesson before & learnt it again. There are no short cuts when moulding parts
Anyway with these parts all you need is the La Seine parts for the bridge face(Rectagle parts at top of face & cranes at bottom) & its accurate. Again I have that kit in transit so if you want the parts you'll have to wait until I get it to do them
Also in the La Sein kit are the square parts those White Road Boss hydrolics sit on top of