09-24-2011, 06:23 AM
Jason
if you haven't hit out the top dome part, you may or may not be interested. allan helped me figure that the plastruct part VHE-600 comes pretty close to the right curve. The overall piece has to be trimmed down, but once the edge is trimmed, the curve height-to-diameter ratio is very close.
if you haven't hit out the top dome part, you may or may not be interested. allan helped me figure that the plastruct part VHE-600 comes pretty close to the right curve. The overall piece has to be trimmed down, but once the edge is trimmed, the curve height-to-diameter ratio is very close.