06-02-2012, 12:59 PM
I have added 15 new pics for the June Reliant Update.
For Reliant I've finished lower saucer dome piece, I've sealed it from the inside of the hull and removed the excess resin so it will be easier to work on the lighting and wiring later on. I have also added the lower saucer detail pieces and epoxied them into oplace from the inside as well. I've had trouble centering the upper piece to the lower one, so I added some edging guides to maker sure the pieces fit together smoothly. you can see this with picture number 4 in the June Updates. The holes for the hanger doors have been widened a bit and a hole for the impulse engine piece and the warp crystal have been cut out and the pieces are now epoxied into place. For the bay doors I've masked off the areas where the lighting effects will come through and I have a couple of good pics (# 9 & 10) that show how masks look. I had to view a few shots in ST:TWOK to find the lighting pattern both from the bottom and the top of the doors. Next I was able to Opaque the pieces using Flat back to cover the entire model to block Light leaks. The next step was to start on the next color for the darker details which in this case is a Light Neutral Gray Paint. I've been able to start the masking of the upper saucer as well. I should have at least one of the next colors added on as well as the two different Aztec patterns that are seen on the filming miniature.
Hope you enjoy this update and I'll see you all next month.!
Mark
http://www.NemVia.com
For Reliant I've finished lower saucer dome piece, I've sealed it from the inside of the hull and removed the excess resin so it will be easier to work on the lighting and wiring later on. I have also added the lower saucer detail pieces and epoxied them into oplace from the inside as well. I've had trouble centering the upper piece to the lower one, so I added some edging guides to maker sure the pieces fit together smoothly. you can see this with picture number 4 in the June Updates. The holes for the hanger doors have been widened a bit and a hole for the impulse engine piece and the warp crystal have been cut out and the pieces are now epoxied into place. For the bay doors I've masked off the areas where the lighting effects will come through and I have a couple of good pics (# 9 & 10) that show how masks look. I had to view a few shots in ST:TWOK to find the lighting pattern both from the bottom and the top of the doors. Next I was able to Opaque the pieces using Flat back to cover the entire model to block Light leaks. The next step was to start on the next color for the darker details which in this case is a Light Neutral Gray Paint. I've been able to start the masking of the upper saucer as well. I should have at least one of the next colors added on as well as the two different Aztec patterns that are seen on the filming miniature.
Hope you enjoy this update and I'll see you all next month.!
Mark
http://www.NemVia.com
"... once it's activated, there's no way to stop it!" - Scotty - DMa