09-21-2013, 01:07 PM
Joe, what Charles says is what i have done with mine. I actually removed a little more material to widen the gap just a bit more to pass the bolt and washer with a little wiggle room. You can see the part he is talking about sticking out of the cross arm. It's an inner sleeve for the pipes.
I can't remember if i needed to trim any of the ROCO or not though. I don't think i had to for this build but i may have needed to do it on that other one. They all will need some bits removed in one way or the other so it's up to you if you mold the bodies as they are or remove those bits so the castings are basicly ready to go. It's probably better to mold em though as they are, you can always remove material from a casting but it's hard putting it back onto the master if needed.
I can't remember if i needed to trim any of the ROCO or not though. I don't think i had to for this build but i may have needed to do it on that other one. They all will need some bits removed in one way or the other so it's up to you if you mold the bodies as they are or remove those bits so the castings are basicly ready to go. It's probably better to mold em though as they are, you can always remove material from a casting but it's hard putting it back onto the master if needed.