Thunderbird 2 scratchbuild 40 inch

[bensmodelworld]

I have a lot done to get the shape wright.
Make all the corners from the pod the same at the bottom.
And have put on more putty were needed for a nice fit to the model.
I have to do the corners from the craft the same as the pod so they have a good match.I have that done with a piece of plastic with the wright curve.
The plastic i held to the corners and have put putty on them and the plastic used as a guide for this.

Tomorrow i hope to do the corners of the craft.And when i have the shape of the pod wright i can do the raised lip on the sides of the craft, for a good fit for the pod.

hope you like the update Regards Ben