10-22-2013, 12:56 AM
The feet/engine disks were surprisingly easy to do (just tedious), once I'd settled on the sizes to use. 1.0mm sheet styrene, then cut 9 large disks ( 32mm / 1.25") and 8 smaller disks (23.5mm / 0.93") and I arrived at the sizes working from my enlarged screen grab.
Since the Tamiya Quad parts are virtually perfect fit on the printout, along with the Lunar Lander pod halves, I have fair confidence the feet/engine disks should be a close match. And, I am indeed aware of the potential for visual distortion, along with the fact that the feet/engine disks are further away from the main body of the model. I consider that a low risk, since they only look to be 5.5cm / 2" away from the Tamiya Quad parts. At least going by this view:
Since the Tamiya Quad parts are virtually perfect fit on the printout, along with the Lunar Lander pod halves, I have fair confidence the feet/engine disks should be a close match. And, I am indeed aware of the potential for visual distortion, along with the fact that the feet/engine disks are further away from the main body of the model. I consider that a low risk, since they only look to be 5.5cm / 2" away from the Tamiya Quad parts. At least going by this view: