10-28-2013, 12:59 AM
Thanks Wombat, I admire your work as well. You fellas (and ladies) here do some amazing work!
Onto more details to finish out the upper deck arrangement. Some T/34 bits, Aurora/Moebius Moonbus, Belfast, Traveling crane and few others. I was only able to figure this section out with Martin's build to follow, he laid quite a patchwork down in there, over 40 pieces I think by the time I finished it up.
Onto some of the sensor pod detailing beginning with arm that holds the sensor dish.
And finally the dish itself. Cut down from the AMT 18" Enterprise. Of note here the dish itself is cut down. IT should be the version with grid lines, I did not discover that until after I had started on this one, so I left it.
On the inner surface run these lines.
Mostly done sensor pod.
Size reference without command pod to a 44" Eagle frame.
Onto more details to finish out the upper deck arrangement. Some T/34 bits, Aurora/Moebius Moonbus, Belfast, Traveling crane and few others. I was only able to figure this section out with Martin's build to follow, he laid quite a patchwork down in there, over 40 pieces I think by the time I finished it up.
Onto some of the sensor pod detailing beginning with arm that holds the sensor dish.
And finally the dish itself. Cut down from the AMT 18" Enterprise. Of note here the dish itself is cut down. IT should be the version with grid lines, I did not discover that until after I had started on this one, so I left it.
On the inner surface run these lines.
Mostly done sensor pod.
Size reference without command pod to a 44" Eagle frame.
Sincerely, Colin Omilusik
http://www.scalemodeltechnologies.com
http://www.scalemodeltechnologies.com