Death Star 2 Port Attack Diorama

[OTnROTSfan]

Finally found somebody local to make acrylic cases and cut large styrene/ABS... spec'd out the large ABS surface piece with the "official" hole that will be clad to the MDF. In the meantime, getting cold out, so time to paint the port (since I had to remove it anyways). Forgot I had only tacked the inside structures in the corners... was hanging that way all summer, but didn't fall into the hole! I remembered when I tried to pick it up and they started falling inside the port... lol. All is good... built a quick temporary cardboard carrier so I can get at most angles of it. First time all the port sections were fully attached and painted. A few sand and putty spots, but actually not too bad overall for first crack at it... will work on that until the surface cladding is done.