Cylon Tanker - 1/2 studio scale

[olcabour]

Thanks.
I finally kept the kit's resin part of the Leopold Gun, but had to modify a lot of details on head and engine modules.

OK, go !

After a serious bath, the cleaning stage begins, starting with the head where there are underlying bubbles under the nose. I sand in the material and covered it with a plastic strip. It is much more faster than to proceed like this when there are no details than trying to fill the holes.

Bubbles:





the edge is sanded:



it is covered with evergreen strip:



and sanding to return to the original shape



Then filling of the other bubbles that remained with plastic rods (hedgehog method )




It lacked a little turret, it is redone. The guns are thin brass rods.