Moebius - Viper mk7

[olcabour]

To hold the socket, I helped myself with the studs and rear landing gear wells. The middle pin was removed to get some space, then I started to sand in the well walls.




To hold the connector, I blocked it with a plastic square, in which 2 slots are made to free the socket metal tabs.
This plate is glued and reinforced with 2 screws. To have more material for the screws, 2 small wooden blocks are installed with hot glue in the landing gear wells.
2 part modeling glue closes the openings around the socket.







Hatches and intakes are glued. The hole of the original support is clogged with plastic card, reinforced from behind again by a mixture of cyano and resin dust.

[url=http://olcabour.hangar.blog.free.fr/public/galactica/viper_mk7_moebius/IMG_4135.JPG][img]http://olcabour.hangar.blog.free.fr/public/galactica/viper_mk7_moebius/.IMG_4135