01-03-2010, 04:14 PM
Scratchy what size FO are you using on the ISD? Im using 0.25mm The 0.25mm drill bits snap under any movement. Anyway on my trip to Bunnings today I stumbled across alluminnium tubing! Stoked so I grabbed a pipe for the Fibre Optics to get stuffed into with the LED's 
Happy chappy. this thing really hasn't got that far to get finished, well if a 1000 or more holes that need to get drilled & threaded isn't much work anyway... But I am getting closer. I have the LED's, the resistors for the LED's to run off 12volt, the wiring, power pack & now the tubing to stuff full of Fibre Optic. So think I'll get back to drilling & filling. Filling the bits that have been thinned too much & drilling the holes for threading the Fibre cause I can now thread sections & stuff into the tubing while I waite for some electrical tutoring.
Happy chappy. this thing really hasn't got that far to get finished, well if a 1000 or more holes that need to get drilled & threaded isn't much work anyway... But I am getting closer. I have the LED's, the resistors for the LED's to run off 12volt, the wiring, power pack & now the tubing to stuff full of Fibre Optic. So think I'll get back to drilling & filling. Filling the bits that have been thinned too much & drilling the holes for threading the Fibre cause I can now thread sections & stuff into the tubing while I waite for some electrical tutoring.