09-15-2014, 04:31 AM
eh up all.
here is another post on the gearbox section,
well i started off makin the add on's to the circular section.
and as you can see i've started on the back and front details,just out of bits and pieces of styrene and me tried and tested lolly sticks.
next i finished off the back bit
on the front bit i had to take my time due to the amount of small detail involved,where the bolts go it has a curved backin,so out with the lollysticks again.
the next tricky bit was to make up the small grill which i used some half mm thick styrene and some half mm thick styrene rod...this did make my eyes go funny.
finally i put my bolts on and finished off the fins on the top half.
and a shot of primer just to see if it's all nice and neat..
well that's it for this post hope ya like...cheers peza
here is another post on the gearbox section,
well i started off makin the add on's to the circular section.
and as you can see i've started on the back and front details,just out of bits and pieces of styrene and me tried and tested lolly sticks.
next i finished off the back bit
on the front bit i had to take my time due to the amount of small detail involved,where the bolts go it has a curved backin,so out with the lollysticks again.
the next tricky bit was to make up the small grill which i used some half mm thick styrene and some half mm thick styrene rod...this did make my eyes go funny.
finally i put my bolts on and finished off the fins on the top half.
and a shot of primer just to see if it's all nice and neat..
well that's it for this post hope ya like...cheers peza