01-06-2015, 12:39 PM
(This post was last modified: 01-06-2015, 12:51 PM by 3d-builder.)
I am making a few changes from the original ......you can see
the other model I have started. WHere the cut out is that creates
the shoulder it had to much arch there so I made a change. There
will also be a change at the rear so there is more of an arch there.
By the way this will be the bottom hull, I have to make the keel a
little different for canopy on the top hull.
the other model I have started. WHere the cut out is that creates
the shoulder it had to much arch there so I made a change. There
will also be a change at the rear so there is more of an arch there.
By the way this will be the bottom hull, I have to make the keel a
little different for canopy on the top hull.