12-19-2017, 05:35 AM
Finally I started cutting plastic on my Lambda Project.
The forward guns are almost done. I will add the base plate and the Bismarck parts later but I still need to ID the circular mounts for the guns though.
I also did the bucks for the side intakes. It was the first time for me doing it so I did 2 to have a spare one, just in case
. The ribs are from styrene, gaps filled with balsa wood and covered in Apoxie and Tamiya putty. My vac form box is ready as well and I will attempt to pull the parts in a few days.
The forward guns are almost done. I will add the base plate and the Bismarck parts later but I still need to ID the circular mounts for the guns though.
I also did the bucks for the side intakes. It was the first time for me doing it so I did 2 to have a spare one, just in case
. The ribs are from styrene, gaps filled with balsa wood and covered in Apoxie and Tamiya putty. My vac form box is ready as well and I will attempt to pull the parts in a few days.