01-26-2010, 07:06 PM
Ok so Im a bit rejuvinated after my birthday break & some good news on another project has given me that kick I needed. So this afternoon have been busy doing stuff & decided it was time to put some shape on the Falcon.
Paper mock up has been drawn, cut & test fit.
Mock up transfered onto 0.75mm tyrene sheet.
Base shape then cut with scalpal
Dome shape test & check on base plan
Cut into quaters & bent to snap neatly
Test fit on main body. Lookin pretty gooood
Oh hell lets turn the lights on & get a better picture of where we goin on this beast
Paper mock up has been drawn, cut & test fit.
Mock up transfered onto 0.75mm tyrene sheet.
Base shape then cut with scalpal
Dome shape test & check on base plan
Cut into quaters & bent to snap neatly
Test fit on main body. Lookin pretty gooood
Oh hell lets turn the lights on & get a better picture of where we goin on this beast