01-27-2010, 07:59 PM
Jase,Mark,cheers once again guy's!!
Jase,The LED's came pre wired and with the resistors already fitted.Just needed to be hooked up to the power wires and bob's ya uncle as they say.
Doug,yeah i've gone right on the edge of that side block.It just doesn't have enough meat there because of the shape of it.Thats because it's basicly just enough there for the coupler to fit in and not much else really.I didn't wanna take a chance that the pin's might earth against the armature.So like i said,i went right on the edge instead.I five minute epoxied the tubing to the body then used epoxy putty and built it up around them and joined it to the side of that block instead.The tubing is sticking inside 20mm so there is a good hold on them to the block and i can't see em moving.The side cover Morser part covers the tubing no problems at all.As you'd already know there,that Morser part sits up a little off that edge,i nearly got caught out myself there,i'm so glad i looked at the pictures one more time!
Anyway,the rear power tubes are wired and epoxied in place,i just gotta solder the wires up,mount the LED's properly then test it all from each feed point and i think i'm good to join the forwrd and aft section for good.
Unless i've missed something that is???
Jase,The LED's came pre wired and with the resistors already fitted.Just needed to be hooked up to the power wires and bob's ya uncle as they say.
Doug,yeah i've gone right on the edge of that side block.It just doesn't have enough meat there because of the shape of it.Thats because it's basicly just enough there for the coupler to fit in and not much else really.I didn't wanna take a chance that the pin's might earth against the armature.So like i said,i went right on the edge instead.I five minute epoxied the tubing to the body then used epoxy putty and built it up around them and joined it to the side of that block instead.The tubing is sticking inside 20mm so there is a good hold on them to the block and i can't see em moving.The side cover Morser part covers the tubing no problems at all.As you'd already know there,that Morser part sits up a little off that edge,i nearly got caught out myself there,i'm so glad i looked at the pictures one more time!
Anyway,the rear power tubes are wired and epoxied in place,i just gotta solder the wires up,mount the LED's properly then test it all from each feed point and i think i'm good to join the forwrd and aft section for good.
Unless i've missed something that is???