Mike,Jase,guy's that would have been too easy,but the LED's have been cut back already so both connections are the same length.But i'm all good with it now,Ron has helped out once again and seyt me straight on what i have(see model lighting section).
Mark,cheers again mate,i'm getting there ever so slowly.
Doug,alignment issue's?You betcha mate,you are gonna have fun trying to get this area right,or perhaps it was just me.I aint saying what i've done is right,and infact i think i have thing's out just a little,but it don't look too bad really.First i glued the two wing pieces on the bottom,then i stuck with tape,the part that sit's above the entex jps part's.This gave me the area i had to play around with and try and get to work out.I think i'll let you workout what works best for you as i'm pretty sure what i've got can be done betta than i did.Those entex parts sit below the bottom edge the way i've done mine and i just couldn't get the two entex parts to line up the same with the positioning i've ended up with.The two rear brass tubes are not level because of this,but it's something i'm gonna live with!I could have filled the hole and redone on to get it level but i couldn't really be bothered.
Thats just me being slack really!
Mark,cheers again mate,i'm getting there ever so slowly.
Doug,alignment issue's?You betcha mate,you are gonna have fun trying to get this area right,or perhaps it was just me.I aint saying what i've done is right,and infact i think i have thing's out just a little,but it don't look too bad really.First i glued the two wing pieces on the bottom,then i stuck with tape,the part that sit's above the entex jps part's.This gave me the area i had to play around with and try and get to work out.I think i'll let you workout what works best for you as i'm pretty sure what i've got can be done betta than i did.Those entex parts sit below the bottom edge the way i've done mine and i just couldn't get the two entex parts to line up the same with the positioning i've ended up with.The two rear brass tubes are not level because of this,but it's something i'm gonna live with!I could have filled the hole and redone on to get it level but i couldn't really be bothered.
Thats just me being slack really!