USS Cygnus 1/700 - The Black Hole

[szarchie]

A mix of things for this update.  I started to test fit the bow section as well as dry fit a bunch of parts on the center section.  Starts to really look like the Cygnus when the additional parts are on.  For the "nest" parts in the center I had to remove a few mm from the transparent parts to get them to sit properly on the spine sections.  Easy enough but was not expecting that.  The bow armature box sits in the bow structure nicely but there were some extraneous pipes on the inside of the piece that had to be removed.  I just snipped them off with a clippers and then the armature box fit perfectly.  Again, was not expecting that but was an easy fix. Test fitting the wires that will power the engine lights was also fun. Figuring out where to channel them through the scaffolding structure was a bit of a puzzle.  But all part of the fun of this project.