Ok so after sorting the pieces I base coated everthing. i wish I hadn't done that now as I never washed the resin pieces first. Now I know some stuff about moulding & casting I know the kit was cast with a release agent to help remove it from the mould( I will do a thread on moulding & casting in the appropriate section). Because I did not thoriughly wash the pieces the 'Primer' has not attached to the surface as one would hope & now over a period of time is flaking off(damnit
) Here are the pieces 'Primed' & highlight of some repairs.... I then proceeded with a 'Test Fit' & yep everything fittedtogether pretty good. Its wicked how many pictures can be loaded up at the same time, well sort at the same time..
) Here are the pieces 'Primed' & highlight of some repairs.... I then proceeded with a 'Test Fit' & yep everything fittedtogether pretty good. Its wicked how many pictures can be loaded up at the same time, well sort at the same time..