02-01-2010, 03:36 PM
(02-01-2010, 07:30 AM)jasonwright.1972 Wrote: Its scary drilling those armature holes but what youve suggested should work just fine. There are scribe lines on the outside of the hull that show the location. You could just drill in the centre of that then enlarge your hole with the Dremil just enough for you pipe to screw in.
This is what I did. The only safe thing to do as far as I could tell.
Also the cover over the bottom can hide some slop in the hole below so i'd drill that out and attach after the armature is in place and you can correct the hole if mis-aligned.
.
Sometimes I build and think and sometimes I just build.
Sometimes I build and think and sometimes I just build.