While Im still sorting out the lighting for the engine etc I will start on prepparing the supports for the upper hull dome. I cut a shape out from the Base Plan to use as a template for the curved support. I traced that onto some off cut styrene to use what ever I could & not waste any. I then cut that shape out with an exacto knife by running the blade along the lines, scoring into the styren. I then get the styren & bend it until it snaps in a clean line. Neat trick taught to me by 'directorcass., thanks again for that 
I then used the first piece as the template for all the other pieces. No matter haow much you try, unless this stuff is computer cut it will never be 100% the same as the last... Got em all cut & will now move onto secureing them in place with the Lock Tite glue. This is where my project has rested due to being robbed of my cameras in a house robbery a couple of weeks ago. I am please I have now been sent a replacement through insurance & can now continue with this project 
I then used the first piece as the template for all the other pieces. No matter haow much you try, unless this stuff is computer cut it will never be 100% the same as the last... Got em all cut & will now move onto secureing them in place with the Lock Tite glue. This is where my project has rested due to being robbed of my cameras in a house robbery a couple of weeks ago. I am please I have now been sent a replacement through insurance & can now continue with this project