05-27-2010, 12:12 PM
(This post was last modified: 05-27-2010, 12:12 PM by OTnROTSfan.)
I would have felt bad if I didnt' light this baby up... this is just a little different than wiring up some LEDs...
This is the kind of stuff that gets me fired up (when it works). :8) I came up with a cheap sanding trick to make the oblong holes even out and have matching ends... I clamped the metal hole guide to the pipe and used it as a straight-edge to slide/sand the holes even in both directions. It gives uniform straight height, too. The dowel sander is from a cheap foam brush that was just the right size.
Got to paint/mount the back light tube and onto the last one in the front left of the tunnel. Progress - haven't made this much in a while!
This is the kind of stuff that gets me fired up (when it works). :8) I came up with a cheap sanding trick to make the oblong holes even out and have matching ends... I clamped the metal hole guide to the pipe and used it as a straight-edge to slide/sand the holes even in both directions. It gives uniform straight height, too. The dowel sander is from a cheap foam brush that was just the right size.
Got to paint/mount the back light tube and onto the last one in the front left of the tunnel. Progress - haven't made this much in a while!
Kevin
Inspire onto others as you would have them inspire onto you... or something like that...
Inspire onto others as you would have them inspire onto you... or something like that...