07-21-2010, 06:57 PM
I seen them rollers as well,but didn't actually know what they were.OK,so they let the whole bay interior be removeable.Interesting idea that one!I am just planning on doing it with the painting like the original,but in both bays obviously rather than just the one.That was a good idea there Charles,one just the things you could do in there but also the fact as you mentioned it was something that could be done once the rest was built up.Good thinking on that!
Ok,just on my gluing again,i hope it holds together over time.Just want to clarify what i did.When joining the panels,i wet both contact areas with the solvent before joining em together.After it was together and being held in place by the glued edges i ran the glue down the back faces of the panels to fill in what i called the back valley between the panels.I think you understand what i'm saying?I didn't just run the glue down the back to join up the panels,they were bonded first on the edges themselves.Anyway,if it does fall apart i'll know why.Acrylic newbiee with no previous experince or knowledge!
Ok,just on my gluing again,i hope it holds together over time.Just want to clarify what i did.When joining the panels,i wet both contact areas with the solvent before joining em together.After it was together and being held in place by the glued edges i ran the glue down the back faces of the panels to fill in what i called the back valley between the panels.I think you understand what i'm saying?I didn't just run the glue down the back to join up the panels,they were bonded first on the edges themselves.Anyway,if it does fall apart i'll know why.Acrylic newbiee with no previous experince or knowledge!