01-09-2011, 08:46 PM
Well two updates in the one day.It's been a pretty good one build wise on this.I'm happy to say bar the two parts i'm hunting for this is basicly ready for some primer.Got the stuff on the back along with the engine bells as you can see and thems were pretty much the last pieces.I fitted some foam inside the Saturn stage before gluing on the engine bells.My globes stick through the bells a little to have them not sticking out as far,but there is a problem with light escaping between the bell and Saturn stage through the stage joining cutout.So i was hoping this foam would do the trick and fix that problem,which it it did.
I then decided to just make sure the lighting was still working,been quite a while since it's been run.Too bad if it wasn't though as this ones sealed up good,but again no worries,still working sweet.
These halogens to me really throw a light that captures that screen look.They don't look quite that good to the eye,but for pictures...
So a good day it's been and this is pretty much 99% ready for primer,now just them last part's??
Help!!!
I then decided to just make sure the lighting was still working,been quite a while since it's been run.Too bad if it wasn't though as this ones sealed up good,but again no worries,still working sweet.
These halogens to me really throw a light that captures that screen look.They don't look quite that good to the eye,but for pictures...
So a good day it's been and this is pretty much 99% ready for primer,now just them last part's??
Help!!!