01-31-2011, 11:07 AM
One last update before I call it quits for the day. This little bugger was a pain!
I think its still going to need casting seperate. Its actually elevated above the base, leaving a mold lock spot. I was hoping to get the whole wing in one mold, but its obvious now that there will have to be some parts seperate. Hate to do it because it will increase the cost ,but Id rather stay as close to the studio model as I can ..even though its still not going to be 100% accurate in detail .
![[Image: 017.jpg]](http://i90.photobucket.com/albums/k243/panzercreations/Tie%20Bomber/017.jpg)
![[Image: 018.jpg]](http://i90.photobucket.com/albums/k243/panzercreations/Tie%20Bomber/018.jpg)
I think its still going to need casting seperate. Its actually elevated above the base, leaving a mold lock spot. I was hoping to get the whole wing in one mold, but its obvious now that there will have to be some parts seperate. Hate to do it because it will increase the cost ,but Id rather stay as close to the studio model as I can ..even though its still not going to be 100% accurate in detail .