In between making some moulds that should have got done yesterday 
I decided it was time to get the Panther G chasis shaped up.
In getting the part to be whats need the sides had to be removed.
That was easy enugh with some clipper.
Then it had to have what was left of the walls sanded away so it just left the little knobby bits on the inside.
I statted to do the sanding on the sanding belt & quickly stopped when Isaw the plastic start to melt & warp!
No short cuts for this stuff....
Its to valuable toi make a mistake that would render the part unuseable
So sanded it back the old fashion way.
Slowly
It took almost an hour to remove the sides & just leave the inside mounts attached
This will be a 'Master' as is needed twice for the neck & twice for the bay.
I decided it was time to get the Panther G chasis shaped up.
In getting the part to be whats need the sides had to be removed.
That was easy enugh with some clipper.
Then it had to have what was left of the walls sanded away so it just left the little knobby bits on the inside.
I statted to do the sanding on the sanding belt & quickly stopped when Isaw the plastic start to melt & warp!
No short cuts for this stuff....
Its to valuable toi make a mistake that would render the part unuseable
So sanded it back the old fashion way.
Slowly
It took almost an hour to remove the sides & just leave the inside mounts attached
This will be a 'Master' as is needed twice for the neck & twice for the bay.