Ok heres some 'rough' pics of the Landing Gear Down Viper.
You will need to take a good chunk out of the 2 lower thrusters to sit flush with the landing gear bays.
No worries with the Dremel & cutting disk.
This part of the kit require some attention.
Ive 'roughly' wacked together these to get an idea how they go together.
There are still a couple of fine details for the rear sleds as with the front.
The landing gear needs some adjusting to sit flush if wanting it stationary on the ground.
I believe it can be secured strongly enough to support its own weight.
I highly recomend 'LockTite' super glue for this ort of thing.
But get it right the first time....The forward flaps are scratched from spare styrene(not included in kit)
Put together right this will be a great version of the Viper.
If you have any ref of this filming model please share it.
You will need to take a good chunk out of the 2 lower thrusters to sit flush with the landing gear bays.
No worries with the Dremel & cutting disk.
This part of the kit require some attention.
Ive 'roughly' wacked together these to get an idea how they go together.
There are still a couple of fine details for the rear sleds as with the front.
The landing gear needs some adjusting to sit flush if wanting it stationary on the ground.
I believe it can be secured strongly enough to support its own weight.
I highly recomend 'LockTite' super glue for this ort of thing.
But get it right the first time....The forward flaps are scratched from spare styrene(not included in kit)
Put together right this will be a great version of the Viper.
If you have any ref of this filming model please share it.