02-16-2013, 12:58 AM
I got some 1" piping while at Lowe's. I had thought about getting some square styrene tubes from Plastruct or US Plastics, but figured I was already at Lowe's and it was probably cheaper just to do the 1" pipe from them.
I'm also at the same place on the maintenance holes. Trying to figure out how deep as well. I want to work on those before I skin the top & bottom. I was going to try and match up some kit parts with the ref photos in order to figure out the depth, but I'm missing some important donor kits to be able to do that effectively. I wanted to cut into the ribbing I've done in order to use those as support for the wells.
Might email you sometime this weekend to run an idea or two by you. So, fair warning!
-Dave
I'm also at the same place on the maintenance holes. Trying to figure out how deep as well. I want to work on those before I skin the top & bottom. I was going to try and match up some kit parts with the ref photos in order to figure out the depth, but I'm missing some important donor kits to be able to do that effectively. I wanted to cut into the ribbing I've done in order to use those as support for the wells.
Might email you sometime this weekend to run an idea or two by you. So, fair warning!
-Dave