10-10-2013, 11:40 PM
Thanks fellas!
Stefan, you've got a point. I honestly don't know if they used styrene or acrylic. They used acrylic for ther 5-footer so I assumed they did the same for the 32-incher. However, just to make it easier, styrene all around might be the way to go...depending on stength, of course. But I don't want to get ahead of myself. I've talked to quite a bit of machinists and this is the most helpful but I still need to wait and see. If I can get this going, I plan on vac-forming both the hull and plating.
Dave, will wait for your email!
Joe
Stefan, you've got a point. I honestly don't know if they used styrene or acrylic. They used acrylic for ther 5-footer so I assumed they did the same for the 32-incher. However, just to make it easier, styrene all around might be the way to go...depending on stength, of course. But I don't want to get ahead of myself. I've talked to quite a bit of machinists and this is the most helpful but I still need to wait and see. If I can get this going, I plan on vac-forming both the hull and plating.
Dave, will wait for your email!
Joe