found some time to work on this, I was hoping to be much further by now, but just have not had the time 
had to do some fixing here on the castings, the back piece was bigger then the cast with the comb , the best I could come up with was to add filler and blend the two together.
once that was done, I mirrored the comb body to the hull. I sprayed window cleaner to the body then smoothed the aluminum foil to the body so there were no wrinkles to deal with. traced out were the comb should be, added some evercoat to the edge of the comb and gave a good press, the result was a perfect mating
the engines were cleaned up and added. a little primer and paint then it will be glued in place.
had to do some fixing here on the castings, the back piece was bigger then the cast with the comb , the best I could come up with was to add filler and blend the two together.
once that was done, I mirrored the comb body to the hull. I sprayed window cleaner to the body then smoothed the aluminum foil to the body so there were no wrinkles to deal with. traced out were the comb should be, added some evercoat to the edge of the comb and gave a good press, the result was a perfect mating
the engines were cleaned up and added. a little primer and paint then it will be glued in place.