Thanks Stefan. Took a while to figure something out that would work TBH. The many shots in publications, seem to real over saturate the model, hiding much of the tonal changes, so it was a case of sifting through a few books, and images shared online to make it work.
The hues used were.
Reefer Orange (over light grey surface primer)
Boxcar Red (canopy flank area and engine piping)
Rust (nose and some side panels, this is quite a good coat to cover well)
SP Light Lark Grey (panel toning, used very thin and misted over, not a heavy coat)
SP Dark Lark grey ( engine intake and cockpit tubs, also pilots)
Reefer White (pilots)
DH Caboose Red (pilots)
Flesh (pilots)
Engine Black (guns)
Grime (overall misting, very thinned, dusted on)
Turned out a lot of fun, and quite a challenge.
Best regards.....Lee
The hues used were.
Reefer Orange (over light grey surface primer)
Boxcar Red (canopy flank area and engine piping)
Rust (nose and some side panels, this is quite a good coat to cover well)
SP Light Lark Grey (panel toning, used very thin and misted over, not a heavy coat)
SP Dark Lark grey ( engine intake and cockpit tubs, also pilots)
Reefer White (pilots)
DH Caboose Red (pilots)
Flesh (pilots)
Engine Black (guns)
Grime (overall misting, very thinned, dusted on)
Turned out a lot of fun, and quite a challenge.
Best regards.....Lee