Some progress:
The cut out of the armature were a bit short, so i saw it to the correct lenght.
After i carefully milled the hole in the backcover.
Drilled the hole in the alloy sheet as well
Fit's really well now
Just had precut the engine pods to look how they fit in general.
Bit boiling in hot water is needed to get them better in shape on the edges.
The cut out of the armature were a bit short, so i saw it to the correct lenght.
After i carefully milled the hole in the backcover.
Drilled the hole in the alloy sheet as well
Fit's really well now
Just had precut the engine pods to look how they fit in general.
Bit boiling in hot water is needed to get them better in shape on the edges.