02-27-2010, 08:22 PM
Alright after my molding for today it was time to get some shuttle in. I tested the lights cuase now I know how to light stuff i just love light tests 
All good thanks Doug! So now i drilled the holes for the side armatures & rear, well the initial holes to make sure I was on target & 3 strikes is a winner! So while I had drill in hand I thought I better drill the LED holes in the cockpit mount. Ive drilled my holes so the LED.s sit inside pointing out firm. The wiring will run in through the middle & be connected to the section of power board the elictrician gave me. It was bigger but I cut it size. Great gadget for joining multiple wires into power source. All lights get the full 12vlts. Hmm thats it for tonight. Got my second job to wake up to at 2am. Had to work in the rain for the last 4 weekends & Im about over it 
All good thanks Doug! So now i drilled the holes for the side armatures & rear, well the initial holes to make sure I was on target & 3 strikes is a winner! So while I had drill in hand I thought I better drill the LED holes in the cockpit mount. Ive drilled my holes so the LED.s sit inside pointing out firm. The wiring will run in through the middle & be connected to the section of power board the elictrician gave me. It was bigger but I cut it size. Great gadget for joining multiple wires into power source. All lights get the full 12vlts. Hmm thats it for tonight. Got my second job to wake up to at 2am. Had to work in the rain for the last 4 weekends & Im about over it