02-28-2010, 10:50 AM
OK. I just deleted my last response to your last post. I see that some of the mould has come off with the treads. This is because the master parts weren't glued all the way down to the plastic placards under them,and this left undercuts. One of these also has too much glue on it causing it squeeze out. The moulds will need to be remade. Once you have a tear,or a sheared off part - all subsequent parts will have the same defects until fixed,and a new mould made. I'll glue all the placards to my master parts,so that you won't have this problem casting them. This will make it go faster,and it'll be easier for you overall.