02-28-2010, 11:52 AM
Cris what are you on about? All the parts come out fine. Yes some have ripped off some rubber but thats stuff thats at the back & I probably tried cutting it off anyway... The only thing that may or will need to happen to these parts is some sanding to take the backs off. I purposely only loosely glue them down so their easier to slice off or sand back as created gaps. Thats alot easier & cheaper than buying all the kits. I wouldn't have been happy with myself if there were any major hickups. I'll clean the pieces up & show you.
Phil that part I just noticed mate so I pulled the hydrolic things off no problem. The little thingy for the big rear of the big tank & half a crane didn't form properly on the second run but I think thats because I pulled it too early.
Back to work now.
Phil that part I just noticed mate so I pulled the hydrolic things off no problem. The little thingy for the big rear of the big tank & half a crane didn't form properly on the second run but I think thats because I pulled it too early.
Back to work now.