03-30-2010, 05:08 PM
Small update until tomorrow as Im off for the day & going to be solely concentrating on this build all day. Tomorrow I will be picking up my acrylic & styrene supplies. i just have the upper slope to fit which is actually a pain in the butt as it has to sit flush with the engine cover that is or should be removable... May pick up some new tools tomorrow also at Bunnings which I think is the equivilent to Walmart.
ok so the waist is started
engine box is shimmed & now sits fush with engine plate
all even & flush, finally
just the upper slopes to attach
got some 4mm acrylic cut from some scraps at work but needs alot of trimming to fit. Will probaly just get it cut & bevelled at the suppliers.
ok so the waist is started
engine box is shimmed & now sits fush with engine plate
all even & flush, finally
just the upper slopes to attach
got some 4mm acrylic cut from some scraps at work but needs alot of trimming to fit. Will probaly just get it cut & bevelled at the suppliers.