04-10-2010, 03:26 PM
Ok so since everything else is pretty much done have no choice but to work on the ports... 
So that I have. Ihave finished the centre port & am happy with it.
It was 1mm ascue
So I had to crack it open to fix it. It was annoying me
It actually righted itself straight away so I just had to rune some glue down the seam
Glued & cleaned up edges. Is a tidy piece now
Looking good. Much happier now it looks symetrical
So now its these buggers
no choice but to get it over with. Ive sanded all the edges to straighten it up & look tight. Im just trying to decide the best way to do these ridges.
I could glue a few pieces of styrene together & sand the shaped required or I cut the pieces & try to get them to the right shape? The stacking of the styrene & sanding to get the desired shape seems to be a good idea right now? Yes Im stalling.....................
So that I have. Ihave finished the centre port & am happy with it.It was 1mm ascue
So I had to crack it open to fix it. It was annoying me
It actually righted itself straight away so I just had to rune some glue down the seam
Glued & cleaned up edges. Is a tidy piece now
Looking good. Much happier now it looks symetrical
So now its these buggers
no choice but to get it over with. Ive sanded all the edges to straighten it up & look tight. Im just trying to decide the best way to do these ridges. I could glue a few pieces of styrene together & sand the shaped required or I cut the pieces & try to get them to the right shape? The stacking of the styrene & sanding to get the desired shape seems to be a good idea right now? Yes Im stalling.....................