04-12-2010, 02:33 PM
Well operations have slowed considerably to get some time out. All Ive done is work on the F16 hull for the waist slope. Scary stuff but she's come through relatively unscathed. It was close though. So Ive cut the cockpit section off
A test fit. I think another mm or 2 needs to be shaved off the front.
Time to cut through the hull for the waist to slope join. Did it very very slowly with the blade & just went over & over untiol it was through enough to snap
Test fit. Just needs a light sand to sure up the seam at the join
side angle. Looks ok
So now really looking at the parts maps & seeing whats needed for the engine box & waist. There are alot of parts.........................
A test fit. I think another mm or 2 needs to be shaved off the front.
Time to cut through the hull for the waist to slope join. Did it very very slowly with the blade & just went over & over untiol it was through enough to snap
Test fit. Just needs a light sand to sure up the seam at the join
side angle. Looks ok
So now really looking at the parts maps & seeing whats needed for the engine box & waist.
There are alot of parts.........................