(05-01-2010, 02:00 PM)jasonwright.1972 Wrote: Joe when i cast them they had a little flash on the sides. Beez nuts worth. When I gave em a quick clean up it was enough to bring em line to where they actually should be. So their pretty much spot on as is.
Thats good to know,
That way I can use the Rocos to double check the engine box length. Are you and Phil gonna use 1/8 plexi for the curved nose section. I grabbed a piece of 1/8 the other day. And although it bent to the proper curve. It was really trying to spring back. Would 1/16 thick be better in that area. I figure it will be plenty strong, and easier to get the proper curve. I know you guys are in the engine section, but just wanted to know your thoughts on this. Cheers,Joe