06-25-2010, 07:13 AM
Mike no problemo on the parts. Am happy to help. I actually have quite a few spare parts since I picked up original kits. Its simply too cold for resin to cure at the moment here which sucks. My PartA resin does have crystalisation on the empty part of the bucket so when I shake it up it collects the crystals which then get mixed in the pot.... I also gave the resin a ggo stir instead of a shake because of that & it went all milky cloudy??? The bottom of the pot was thick & gooey??? I did a poor with the milky mix & it worked. Just haven't seen it like that before??? I think I'll get some big buckets from work & some paint strainers & strain the mix into fresh buckets. That will remeve any crystals & should work ok.
On the build front not much this week. Am waiting for my parts to come. I lost my 155Howitzer as someone sniped it just before the end of the bidding... Gotta find another one. Also just need the Nitto & the King Tiger parts for the Butt Plate. Everything else is on its way. Didn't get my Engine Plate cut etc due to deleting some bills before school holidays start. Im off for nearly 3 weeks as of Sunday.
On the build front not much this week. Am waiting for my parts to come. I lost my 155Howitzer as someone sniped it just before the end of the bidding... Gotta find another one. Also just need the Nitto & the King Tiger parts for the Butt Plate. Everything else is on its way. Didn't get my Engine Plate cut etc due to deleting some bills before school holidays start. Im off for nearly 3 weeks as of Sunday.