(07-30-2010, 05:41 PM)star-art Wrote: Those JPS cockpit parts are very thin. The key to successfully casting them in resin is to use the right resin (I hear something called "hard cast" is the one to get) and to leave them in the mold for at least 24 hours to make sure they are fully cured. You should also keep the molds nice and warm to make sure the resin fully catalyzes. Hope that helps!
Hey Charles,
Would you have a line on where to get that "Hard Cast" resin. I did a Google search, and asked around, but not joy so far. Thanks in advance,
Joe
Oops, checked Google again, and found it. It's by Silpak. Heres the page I found.
http://www.silpak.com/casting-materials/...ne-plastic