Hahahaha 
Funny Doug. I like the thought. had some excellent success today & am 'extremely' happy with what I got done this afternoon. I have the body all assembled & aligned. Its been a big arvy with my mate Dremel & my workshop has acrylic everywhere but its been worth it. Im just so happy to have this hard part out of the way. Hard part? getting the floor on the body through & around the armature! Imarked where the pipe sits. Traced a circle, drew a line through the centre width wise & then cut about 50 times over & over with my stanley knife. I then secured the acrylic with the cut on the edge of my bench & snapped her clean off. Yeeharr I was impressed. Saved me some money from not having to replace if I screwed it up. Which I expected to do. I then got the cutting circle into her & took as much out as possible then hooked in the Dremel ro clean things up. I am seriously so stoked & relieved I have this out the way. 
Funny Doug. I like the thought. had some excellent success today & am 'extremely' happy with what I got done this afternoon. I have the body all assembled & aligned. Its been a big arvy with my mate Dremel & my workshop has acrylic everywhere but its been worth it. Im just so happy to have this hard part out of the way. Hard part? getting the floor on the body through & around the armature! Imarked where the pipe sits. Traced a circle, drew a line through the centre width wise & then cut about 50 times over & over with my stanley knife. I then secured the acrylic with the cut on the edge of my bench & snapped her clean off. Yeeharr I was impressed. Saved me some money from not having to replace if I screwed it up. Which I expected to do. I then got the cutting circle into her & took as much out as possible then hooked in the Dremel ro clean things up. I am seriously so stoked & relieved I have this out the way.