11-07-2010, 12:18 PM
(11-07-2010, 12:23 AM)427 Cobra Wrote: I love the ribbing. I was going to suggest 0.10" styrene rod laid side by side for the ribs to make it a little easier. You could glue them all lengthwise with a 0.10" thick styrene sheet in between to separate them until they're placed. This would make them perfectly even without small twists, or uneveness. Of course, you'd have to cut each section to the width of the neck once dry. Use this method on your next build, or just for practice. It works really well for me!
~ Cobra Chris
CC, that's a good suggestion..... wish I would've thought of it at the time though. There's still some areas on this build that I haven't started yet, if you, or anyone else have any ideas, feel free to mention them, I welcome all constructive feedback.... as long as it's on an area that isn't finished or partially started, I don't like going back into my work
