Triangle Ship

[darkimmitator]

Like the subject says , The ragtag ship called the Triangle ship . This is the Chris Larson Kit with the casted bits swaped out for the actual kit parts .

[3phase]

Nice one mate, what was the kit like without replacing the kit parts.

[darkimmitator]

Thank you 3Phase . The kit is not too bad at all . Some flash cleanup and some pinholes as per most resin kits ,no instructions , but there is enough visual ref. on the net to get the job done .The details are crisp . I used the actual kit parts because I already had them on hand ,and it saved me some time on cleaning up the parts .

[dbhs]

Wow, you've been busy. Awesome work. Your weathering looks fantastic.

What kit does the parts on top of the wing ( just inside the bracket with the holes) come from? I'm referring to the small rectangular block with the 'S' shaped thin round bar that sticks out toward the front.

[darkimmitator]

Thanks again Doug . When I get the mojo goin , I can accomplish a fair amount . The trick is just to keep the mojo going !! I believe it was the 88mm gun flak, for that part . I will check for the sprue number .Discovered that one while looking for something else !

[JAWS]

Niice.
Kit?
Didn't see this one pop up....
Thanks for the update& good to see you back.

[darkimmitator]

Thanks Jase , great to be back at it . Just about ready to do a big G update as well .

[dbhs]

Kenny, I didn't see it on the 88 kit scans. No rush but I would like to add that part on when I get to starting on mine.

[Snake Plissken]

Here you go.

[dbhs]

Thanks. I was hoping it would be the Hasegawa kit but no luck. Looks like quite a few other useful bits in there too.

[JAWS]

Link to the kit please!

[3phase]

I think it might be this one by Larson. They also do a movers kit.


http://www.modelermagic.com/?p=46978

[darkimmitator]

That would be the one .